• Simple home controller that supports monitoring sensors and performing automated actions
  • for example, turning on lights according to schedule or when a sensor is activated
• Suports selected devices from these brands
  • Shelly
  • Govee
  • Ecowitt
  • Tesla
• Provides a BASIC interpreter
  • Automation scripts
  • Live control and debugging

sudo apt install git build-essential cmake gcc-arm-none-eabi libnewlib-arm-none-eabi libstdc++-arm-none-eabi-newlib

git clone --recurse-submodules https://github.com/NewmanIsTheStar/thermostat.git
cd thermostat
mkdir build
cd build
cmake ..
make

Upon completion of a successful build the file thermostat.uf2 should be created. This may be loaded onto the Pico2 W by dragging and dropping in the usual manner.

• The Pico will initially create a WiFi network called pluto. Connect to this WiFi network and then point your web browser to http://192.168.4.1
  • Note that many web browsers automatically change the URL from http:// to https:// so if it is not connecting you might need to reenter the URL.
• Set the WiFi country, network and password then hit save and reboot. The Pico will attempt to connect to the WiFi network. If it fails then it will fall back to AP mode and you can once again connect to the pluto network and correct your mistakes.
• Use the GPIO settings page to configure the hardware connections for relays, temperature sensor, display and buttons

• Raspberry Pi Pico2 W

• SPDX-License-Identifier: BSD-3-Clause
• SPDX-License-Identifier: MIT